Pattern: hopper - offset - oblique - Dialog - Input parameters
Configuration: Change
- Development precision [divisions]: 48
- DXF text height: 3
- Input and drawing file units: Millimeters
Some tips related to this pattern:
- Input measurements are internal.
- Centered objects can be obtained by setting the offset inputs to 0 (ZERO).
- By inputting X2=X1, Y2=Y1, AND dY=dX=0, you can generate a straight rectangular duct.
- The bending lines can be considered as bends [almost sharp corners] if using minimal inside bending radius (R int ~ 1.29 * T), or as cutting lines that form a V-groove corner joint.
- Angle input = 0 (zero) gives a parallel pattern
- Angle inputs are in degrees.
IMPORTANT:
- You must be logged in to download patterns.
- Pattern downloads are only available to users with active TRIAL status OR an active registration or subscription and sufficient credits.
